First, the pulse valve and control device with a square line link up, the pulse valve has three connectors, a ground wire (color), a front-line (red), and other utility lines (green), 4 solenoid valve on the front line of the control cabinet front-line sequential link up to 4 solenoid valve on the common line with a line of convergence with, and then link up with the utility lines to the control cabinet. 
 Second, the pulse controller to use and maintain the use of the former First connect the electromagnetic valve, careful to check whether correct wiring, and then turn the power on. If the solenoid valve has compiled a good number, see if you can from "0" the beginning of the output. Based on look at the pulse transferred to the ideal distance and width after ended. MOS digital integrated block access to the circuit is very stable. Digital tube a short time earlier to kindle and weight code, SCR flexible through the high caused by. Should be reduced to promote the value of β tubes 3DG, or pole, and to parallel the one between 300Ω-2KΩ The thyristor-controlled resistor. If the rendering Always first check the SCR whether breakdown or leakage. Showing the status of Dropouts ordinary monostable circuit faulty transistor β value. Circuit showing the impact of interference signals in flip count. 
 , Impulse control, attention to matters 
 a) the pulse controller output connector is prohibited Weld and poor contact. Often due to poor contact electrical spark caused by interference will affect the normal work of the entire circuit. Necessary to arouse attention. 
 b) The public line of stand-alone output only to provide stand-alone use, multi-machine use the output of local stand-alone single then, must coordinate with each other. 
 c) 20 door 14 controller output common lines independent terminal or a line of other colors, the solenoid valve 20 output plug one end of the other end to the public online. Controller output within 20 public lines common to be the last, the wire color is also different, Please note that device. 
 Pulse controller works: 
 Pulse control device is issued a pulse signal, the control of pneumatic valve or solenoid valve, pulse valve injection light gray. The pulse signal generator is a pulse jet bag filter control mechanical transmission, directly one by one trigger pulse valve injection. 

 Pulse controller to use the Note: 
 1, input voltage: 220V 
 2, the output voltage: AC110V/DC24V/AC220V Operating Temperature: Temperature -20 ℃ ~ 50 ℃ 
 3, the air temperature:?; 85% 
 4, the working environment without serious corrosive gas and conductive dust, no severe vibration or shock 

 Pulse controller technical indicators: 
 Pulse width of 0.05-0.2 seconds pulse interval of 1.99 seconds 
 Cycle time of 0-250 minutes working voltage 220VAC-50HZ 
 Output current 900mmA output voltage of 24V, 110V, 220V 
 Ambient temperature-20C20% & <80%